Monster.ca

Electrical Substation / Relay Repairer

Radio Frequency (RF) Engineer

Engineering Test Technician

Biomedical Electronics Technician

Avionics Technician

A Radio Technician tests, inspects and repairs radio and wireless broadcast and communications equipment. Often requires driving to locations, sometimes remote to perform on site technical support. 

Electronics Technician (General)

Radio Technician

In radio engineering, an antenna or aerial is the interface between radio waves propagating through space and electric currents moving in metal conductors, used with a transmitter or receiver. In transmission, a radio transmitter supplies an electric current to the antenna's terminals, and the antenna radiates the energy from the current as electromagnetic waves. In reception, an antenna intercepts some of the power of a radio wave in order to produce an electric current at its terminals, that is applied to a receiver to be amplified. Antennas are essential components of all radio equipment.

Antenna

Baseband is a signal that has a near-zero frequency range, i.e. a spectral magnitude that is nonzero only for frequencies in the vicinity of the origin and negligible elsewhere. In telecommunications and signal processing, baseband signals are transmitted without modulation, that is, without any shift in the range of frequencies of the signal. Baseband has a low frequency—contained within the band from close to zero hertz up to a higher cut-off frequency. Baseband can be synonymous with lowpass or non-modulated, and is differentiated from passband, bandpass, carrier-modulated, intermediate frequency, or radio frequency (RF).

Baseband

A signal generator is one of a class of electronic devices that generates electronic signals with set properties of amplitude, frequency, and wave shape. These generated signals are used as a stimulus for electronic measurements, typically used in designing, testing, troubleshooting, and repairing electronic or electroacoustic devices, though it often has artistic uses as well.

Signal Generators

A spectrum analyzer measures the magnitude of an input signal versus frequency within the full frequency range of the instrument. The primary use is to measure the power of the spectrum of known and unknown signals. The input signal that most common spectrum analyzers measure is electrical; however, spectral compositions of other signals, such as acoustic pressure waves and optical light waves, can be considered through the use of an appropriate transducer. Spectrum analyzers for other types of signals also exist, such as optical spectrum analyzers which use direct optical techniques such as a monochromator to make measurements.

Spectrum Analyzer

In radio engineering and telecommunications, standing wave ratio (SWR) is a measure of impedance matching of loads to the characteristic impedance of a transmission line or waveguide. Impedance mismatches result in standing waves along the transmission line, and SWR is defined as the ratio of the partial standing wave's amplitude at an antinode (maximum) to the amplitude at a node (minimum) along the line.

Location	Median Salary
Cantley, Quebec	$28.18
National	$28.18
Location +/-	0% Higher
	Search another salary
	Show me related jobs

Location	Median Salary
Cantley, Quebec	$28.18
National	$28.18
Location +/-	0% Higher
	Search another salary
	Show me related jobs

Hourly Estimate for Cantley, Quebec
Nearby Locations...

Salary Details

Boost Your Value

Boost Your Value

Advance your career

Advance your career

Jobs In on Monster

Radio Technician Hourly Estimate for Cantley, QuebecNearby Locations...

Salary Details

Boost Your Value

Boost Your Value

Salary for Related Jobs

Salary for Related Jobs

Advance your career

Advance your career

Jobs In on Monster

Hourly Estimate for Cantley, Quebec
Nearby Locations...